Lawn tractors are an important tool for maintaining large lawns and gardens. These machines are equipped with different components that work together for efficient operation. One of the most important components is the tire, which helps in moving the tractor. However, like any other tire, the lawn tractor's tire can go flat or even wear out. When this happens, the inner tube needs to be removed and replaced. Putting an inner tube into a lawn tractor tire might seem challenging at first, but with the right tools and method, it can be easy. In this article, we will discuss how to put the inner tube in a lawn tractor tire.
Gather the Tools You Will Need
Before you begin the process of putting an inner tube into a lawn tractor tire, you need to gather all the necessary tools. These tools are readily available in your local store or online, and they include:
- Flathead screwdriver or tire-lever tool
- Tire pressure checker
- New inner tube
- Tire patch and glue
- Wrench or pliers
Remove the Damaged Inner Tube
The first step in putting an inner tube into a lawn tractor tire is removing the old or damaged inner tube. Before you start, make sure the tire is not attached to the tractor and deflated. Once you have done that, use a tire-lever tool or flathead screwdriver to remove the valve cap. After removing the valve cap, use the tool to push the core of the valve to let the air out.Once the tire is deflated, use the same tool or a wrench to pry off one side of the tire. When one side is off, remove the inner tube from the tire by pulling it out through the other side. Inspect the rubber for any damage, and if there is damage, cut it out with scissors. Be careful not to cut through the entire tire.
Install the New Inner Tube
Once you have removed the old inner tube, you can install the new one. Start by applying a light layer of talcum powder inside the tire. The powder helps to keep the inner tube lubricated in the tire. Also, make sure the valve stem of the inner tube aligns with the valve hole in the rim.After that, carefully insert the inner tube into the tire and place the valve stem through the valve hole. Ensure that the tube is centered and not twisted. Then, push the tire back onto the rim, starting from the valve stem end.
Rewire the Tire Back
After you have installed the new inner tube in the tire, use a tire lever tool or a wrench to push the tire back onto the rim. Make sure the tire is evenly distributed around the rim to prevent pinching. Then, inflate the tire to the recommended pressure using a tire pressure checker.Once the tire is inflated, check for any leaks. If there are no leaks, then reinstall the valve cap and reattach the tire to the lawn tractor. If there is a leak, locate the hole in the tube and apply some tire patch and glue to seal it.
Conclusion
Putting an inner tube into a lawn tractor tire may seem challenging, but it's quite easy with the right tools and method. Make sure you gather all the tools you need beforehand, remove the old or damaged inner tube carefully, install the new inner tube correctly, and then rewire the tire back. Following these steps will help you get your lawn tractor moving again in no time.
