When it comes to maintaining your property or working on a farm, a bush hog attachment on a Kubota tractor is one of the most useful tools you could have. However, before you can begin to use it, you need to know how to engage it properly. In this article, we'll go through the steps required to engage the bush hog on your Kubota tractor so that you can get started with your work.
Step 1: Get Your Tractor Ready
Before you can engage the bush hog, you'll need to make sure your Kubota tractor is properly set up. Begin by starting the engine and letting it idle for a few minutes until it reaches operating temperature. Then, make sure the tractor's transmission is in neutral and set the parking brake to prevent any accidental movement.
Next, inspect the bush hog thoroughly to make sure it's free of any debris or damage. Check the blades and the gearbox for any signs of wear or damage, and make sure the driveline is properly connected to both the tractor and the bush hog.
Step 2: Lower the Bush Hog
The next step is to lower the bush hog to the ground. To do this, you'll need to use the hydraulic controls on your Kubota tractor. Locate the hydraulic control lever on the side of the tractor and engage it in the \"lower\" position. Slowly lower the bush hog until it touches the ground. Once it's on the ground, disengage the hydraulic controls.
Step 3: Engage the PTO
Now that your bush hog is on the ground, it's time to engage the PTO (power take-off) on your Kubota tractor. The PTO is what powers the blades on the bush hog. Locate the PTO control lever on the side of the tractor and engage it in the \"on\" position. This will cause the driveline to start turning.
At this point, you should be able to hear the blades on the bush hog start to turn. If you don't hear anything, disengage the PTO and check to make sure the driveline is properly connected.
Step 4: Raise the Bush Hog
Now that the PTO is engaged and the blades are turning, it's time to raise the bush hog off the ground. To do this, engage the hydraulic controls on your Kubota tractor and select the \"raise\" position. Slowly raise the bush hog until it's at the desired height. Once it's at the right height, disengage the hydraulic controls.
Conclusion
Engaging the bush hog on your Kubota tractor is a simple process that can easily be mastered with practice. By following these four steps, you should be able to engage your bush hog safely and efficiently, allowing you to get your work done quickly and effectively.