how to replace rubber seal on lg front load washer

LG front load washers are known for their superior performance and efficiency. However, over time, the rubber seal around the door can wear out, deteriorate, and accumulate mold and mildew. Replacing the rubber seal is not only important for hygiene but also for the longevity and efficiency of your washing machine. In this article, we will guide you through the steps of replacing the rubber seal on your LG front load washer.

Step 1: Preparation

Before starting, make sure you have all the necessary tools and supplies. You will need a new rubber seal, a screwdriver, a sharp knife or blade, rubbing alcohol, and a clean cloth. Turn off the power and unplug the washing machine. It is also a good idea to remove any laundry from the drum and clean the inside of the machine with a damp cloth.

Step 2: Removing the Old Rubber Seal

The rubber seal is held in place by a retaining ring located on the front of the drum. Using a screwdriver, carefully loosen and remove the retaining ring. Pull the old rubber seal away from the drum and carefully remove it from the plastic lip it is attached to. Be careful not to damage the lip or the drum.

Step 3: Cleaning

Once the old rubber seal is removed, clean the area thoroughly with rubbing alcohol and a clean cloth. Pay extra attention to the area around the lip where the seal was attached, as this is where mold and mildew tend to accumulate. Make sure the area is completely dry before continuing.

Step 4: Installing the New Rubber Seal

Unpack the new rubber seal and carefully insert it into the plastic lip. Make sure the seal is properly aligned and sitting flat against the plastic. Use a sharp knife or blade to trim any excess rubber. Once the seal is in place, replace the retaining ring using a screwdriver to tighten it back into place.

Step 5: Finishing Up

After installing the new rubber seal, run a short cycle of your washing machine with no laundry to make sure everything is working properly. Check for any leaks or unusual sounds. If everything looks and sounds good, congratulations - you have successfully replaced the rubber seal on your LG front load washer!

Conclusion

Replacing the rubber seal on your LG front load washer can seem daunting, but it is a simple process that can be completed by anyone with a bit of DIY skill. By following these steps, you can ensure the hygiene and longevity of your washing machine. Remember to always prioritize safety, and if you are unsure about any step, consult a professional.