how to load a scotch packaging tape dispenser
Release time：2023-07-02 08:36:52
Page View：
author：Yuxuan
Scotch packaging tape dispensers are widely used in shipping, moving, and packaging. They are easy to handle and provide maximum adhesive strength. However, loading a scotch packaging tape dispenser can be a daunting task if you are not familiar with it. In this article, we will guide you on how to load a scotch packaging tape dispenser step by step.
Step 1: Open the Dispenser
The first step in loading a scotch packaging tape dispenser is to open it up. To do this, locate the release button or lever at the end of the dispenser. Push the release button or lever to open the dispenser. This will expose the tape roll holder mechanism.Step 2: Remove the Used Tape Roll
After opening the dispenser, remove the used tape roll by pulling it out of the holder. If the tape roll has already been used up, discard it safely. If there is still some tape left on it, save it for later use.Step 3: Prepare the New Tape Roll
Take the new tape roll and remove the protective cover from the sticky side of the tape. Ensure that the tape is properly aligned with the adhesive wheel by placing it on the holder and then rotating it until it is in the desired position. Most scotch packaging tape comes with a precut slit that makes it easier to slide onto the holder.Step 4: Load the Tape Roll onto the Holder
Once the tape roll is in the desired position, gently press it down onto the holder until it clicks into place. Be careful not to apply too much pressure as this can damage the dispenser. Ensure that the tape roll is centered and cannot move around by gently tugging on it to ensure that it is securely attached to the holder.Step 5: Thread the Tape
After loading the tape roll onto the holder, pull out a small amount of tape and draw it across the dispenser's blade. You may have to rotate the sticky wheel to assist with this. Ensure that the tape is threaded over the blade and around the adhesive wheel before pressing the top of the dispenser down to prevent dirt and dust from getting in the dispenser.Conclusion
In conclusion, loading a scotch packaging tape dispenser is a relatively easy process. The key is to ensure that the tape roll is properly aligned, securely attached to the holder, and that the tape is threaded over the blade and around the adhesive wheel. By following these steps, you can save time and ensure that the tape dispenser is working properly, giving you maximum adhesive strength.
