how to load a 3m shipping tape dispenser

Using a 3m shipping tape dispenser can greatly ease the process of packaging and shipping goods. However, loading the dispenser can be a daunting task, especially for those who are not familiar with the equipment. In this article, we will outline a step-by-step guide on how to load a 3m shipping tape dispenser.

Step 1: Prepare the Dispenser

Before you can begin loading your dispenser, you need to make sure it is clean and ready for use. Start by removing any leftover tape or debris from the dispenser. Check for any damage or wear and tear that may compromise its functionality. If the dispenser is damaged in any way, it is best to replace it with a new one.

Step 2: Load the Tape Roll

To load the tape roll, start by opening the dispenser’s flap. Then, remove the empty roll from the dispenser. Take your new tape roll and insert it onto the dispenser’s mandrel. Make sure that the sticky part of the tape is facing downwards. Once the tape roll is securely in place, pull a small amount of tape out from the dispenser.

Step 3: Thread the Tape

After the tape roll has been loaded, you need to thread the tape through the dispenser. Take the end of the tape that you previously pulled out and thread it through the guide rollers. Ensure that the tape is pressed against the metal guides and has no folds or creases. Pull the tape through until it reaches the blade.

Step 4: Cut the Tape

Once the tape has been threaded, it’s time to cut it to the desired length. To do this, depress the lever at the front of the dispenser. This will cause the blade to lower, allowing you to cut the tape. Once the tape has been cut, release the lever and it will return to its original position.

Conclusion

Loading a 3m shipping tape dispenser is a simple process that, once mastered, can save you time and energy. By following the steps outlined in this guide, you will be able to load your dispenser with ease, ensuring that your packages are securely sealed and ready for shipping. Remember to always check your dispenser for any damage or wear and tear and replace it if necessary. Happy packaging!"