how to clean whirlpool front loader washing machine filter

A front loader washing machine is efficient in cleaning your clothes, but the maintenance required to keep it in good working condition may overwhelm some people. One of the things you need to do regularly is to clean the washing machine filter. The filter collects lint, hair, and other debris that your clothes shed during each wash cycle. Cleaning the filter will help your washing machine operate efficiently and prevent damage to the drain pump. Here are the steps to follow to clean the filter of a Whirlpool front loader washing machine.

Step 1: Turn off the washing machine

Before you start cleaning the filter, make sure that the washing machine is turned off. Unplug it from the power outlet or turn off the circuit breaker that supplies power to the washing machine. Doing this will prevent any electrical mishap while you clean the washing machine.

Step 2: Locate the filter

The filter is usually located at the bottom right or left corner of the washing machine's front panel. Look for a rectangular panel that you can remove to access the filter. If you're unsure where the panel is located, check the washing machine's manual.

Step 3: Open the filter compartment

Use a screwdriver or a coin to turn the filter compartment's knob counterclockwise. Be prepared to catch any water that comes out of the filter. If the filter is clogged or blocked, water will spill out when you open the filter compartment. Use towels or rags to clean up any spilled water.

Step 4: Remove and clean the filter

Once you open the filter compartment, you'll see the filter attached to the pump. Gently pull the filter out using your fingers. Be careful not to force the filter out as it might break. Clean the filter with warm water and mild soap. Remove any lint, hair, and debris that accumulated on the filter. Make sure that you remove all the debris to avoid clogging the filter again.

Step 5: Reinstall the filter and test the washing machine

After cleaning the filter, reinstall it into the pump and secure it with the compartment knob. Make sure that the knob is tightened firmly to avoid any leaks. Turn the washing machine on and run it through a cycle to test its operation. Check for any leaks and verify that the washing machine is draining efficiently.

Conclusion

Cleaning the filter of a Whirlpool front loader washing machine is not as complicated as it may seem. Following these simple steps will help you maintain the efficiency and functionality of your washing machine. Plan to clean the filter every two to three months, depending on how often you use the washing machine. Not only will cleaning the filter ensure the longevity of your washing machine, but it will also help you achieve clean, fresh-smelling clothes every time.