how to load riding mower on truck without ramps

Riding mowers are heavy machines, and transporting them can be a tough task, especially when you don't have a pair of ramps. While there are different methods to load a riding mower on a truck or trailer, most of them require some kind of support from a ramp or a slope. However, in this guide, we will show you how to load a riding mower on a truck without ramps using three simple yet effective methods.

The Pillow method

The pillow method is a popular technique that uses pillows or cushions to load a riding mower on a truck. The first step to this method is to park the riding mower on a flat surface and shut off the engine. You will also need to measure the distance between the rear wheels and the ground. This distance will determine the type of pillow you will need. For example, if the distance is four inches, you will need a pillow that is at least four inches thick.Next, place the pillows or cushions behind the rear tires of the mower and slowly drive the machine up the pillows. As you do this, make sure to keep the machine straight. Once the mower is fully on the pillows, place some wood blocks behind the wheels to prevent it from rolling backward.

The Rampless method

The rampless method is a technique that uses a jack and a piece of plywood to load the mower on the truck. To start, park the mower on a flat surface and secure the brakes. Next, place a 12x12 inch piece of plywood in front of the mower. Then, slowly drive the mower over the plywood until the front wheels are touching it.After that, place the jack under the front end of the riding mower and lift it up just enough for you to slide the plywood underneath. Lower the jack slowly, making sure the front of the mower is positioned at the center of the plywood. Now, you can gently drive the mower up the plywood and onto the truck bed.

The Roping method

The roping method is a technique that requires a little bit of strength and some sturdy ropes. Begin by positioning the truck parallel to the riding mower, leaving at least ten feet of space between the two. Then, tie a rope to the rear of the mower, and another one to the front.Next, lower the tailgate of the truck and attach the two ropes to the truck bed. Make sure the ropes are tight and secure. You can then slowly pull the mower up the bed of the truck using the ropes. As you do this, make sure to apply steady pressure to the ropes, and keep the machine straight at all times.

Conclusion

Loading a riding mower on a truck without ramps may seem like a challenging task at first glance, but it is entirely doable with the right methods. The pillow method, the rampless method, and the roping method are just a few ways to get the job done. Whichever technique you choose, always ensure that you remain safe throughout the process and that everything is secure before transporting your mower.
"