how to drain electrolux front load washer

Introduction

Electrolux front load washers are known for their high-quality performance. Over time, even the best machines can develop problems and require maintenance. One of the most common issues that Electrolux front load washers encounter is the inability to drain properly. This article will provide you with a step-by-step guide on how to drain an Electrolux front load washer.

Step 1: Turn off the Power

Before trying to drain the washer, you need to make sure that it's turned off and unplugged. This will prevent you from getting electrocuted or damaging the machine. Unplug the washer from the power outlet, and turn off the power supply by flipping the circuit breaker switch.

Step 2: Locate the Drain Filter

Next, you need to locate the drain filter. The filter is usually located at the bottom of the machine, behind a small door. To access it, you may need to remove the kick panel at the front of the washer. Once you have located the filter, use a screwdriver to remove the screws or clips that are holding the cover in place.

Step 3: Drain the Water

With the filter cover removed, you can now drain the water from the machine. Place a shallow dish or bowl under the filter assembly to catch any water that may spill out. Then, carefully unscrew the filter and pull it out. Tilt it slightly to one side to allow the water to drain into the bowl.

Step 4: Clean the Filter

Once you have drained the water, you need to clean the filter. The filter is likely to be clogged with dirt, lint, and other debris that has accumulated over time. Use a soft-bristled brush or a cloth to clean the filter thoroughly. Make sure to remove all the debris that has accumulated, and then rinse the filter with clean water.

Step 5: Reassemble the Washer

Finally, reassemble the washer. Place the filter back in its housing, and screw it in place. Then, replace the cover and secure it with the screws or clips. Plug in the washer and turn on the power supply. Run a test cycle to ensure that the washer is draining properly.

Conclusion

Draining an Electrolux front load washer is a relatively simple process that can be done at home with just a few basic tools. By following these steps, you can ensure that your washer is working properly and avoid the need for expensive repairs or replacements. If you encounter any problems with draining your washer, be sure to consult the manufacturer's manual or call a professional for assistance.