how to replace heating element in whirlpool front load dryer

Replacing the heating element in your Whirlpool front load dryer can be a daunting task, but it is a necessary one when your dryer is not producing any heat. The heating element is responsible for producing the hot air that dries your clothes. A malfunctioning heating element can cause your dryer to take longer to dry clothes, consume more energy, and even damage your clothes by causing wrinkles or shrinkage. In this article, we will discuss the steps you need to take to replace the heating element in your Whirlpool front load dryer.

Step 1: Safety First

Before you begin this task, disconnect your dryer from its power source by unplugging the power cord or turning off the breaker. You don't want to risk electrocution while working on your dryer. Wear protective gloves and glasses to prevent injury.

Step 2: Gain Access to the Heating Element

Next, you will need to remove the front panel of your dryer to access the heating element. To do this, you will need to remove the two screws at the bottom of the front panel, then release the clips at the top of the panel by pulling it forward and lifting it up. Be sure to set the panel aside where it won't get damaged.

Step 3: Remove the Old Heating Element

Now that you have access to the heating element, you will need to disconnect it from the wires and remove it from the dryer. First, disconnect the wires by pulling them from the old heating element's terminals. Then, use a screwdriver to remove the screws that are holding the heating element in place. Once the screws are removed, you should be able to pull the heating element out of the dryer.

Step 4: Install the New Heating Element

Now it's time to install the new heating element in your Whirlpool front load dryer. Simply reverse the steps you performed to remove the old heating element. First, slide the new heating element into the appropriate slots in the dryer. Then, use the screws to secure it in place. Finally, reconnect the wires to the new heating element terminals.

Step 5: Reassemble Your Dryer

Once the new heating element is installed, it's time to reassemble the front panel of your Whirlpool front load dryer. Carefully align the clips at the top of the panel, then push it back into place until it snaps securely into position. Finish by reattaching the two screws at the bottom of the panel.

Conclusion

Replacing the heating element in your Whirlpool front load dryer is a fairly straightforward process, but it does require some basic tools and safety precautions. If you follow the steps outlined in this article, you should be able to replace your dryer's heating element without any issues. With a new heating element, your dryer should work better and more efficiently, giving you faster and more thoroughly-dried clothes.