how to replace rubber seal on whirlpool front load washer

Front load washing machines have become a household necessity due to their efficient washing and cleaning capabilities. One of the most common issues that may arise in a front load washer is a worn-out rubber seal. Replacing a rubber seal in a front load washer may seem like a daunting task, but with some basic tools and a little bit of patience, it can be done in no time. In this article, we will guide you through the steps to replace the rubber seal on a Whirlpool front load washer.

Tools Required

Before attempting to replace the rubber seal on a Whirlpool front load washer, you will need the following tools:- Pliers- Screwdriver- Razor blade or sharp knife- Replacement rubber sealMake sure to purchase the correct replacement rubber seal for your Whirlpool front load washer model, as different models may require different seals.

Preparing for the Replacement

Firstly, turn off the power supply to your front load washer by unplugging it from the power outlet. Next, remove the detergent drawer by pulling it out and pressing on the release tab located on the back of the drawer. After that, remove any screws that are securing the control panel to the washer using a screwdriver. Carefully lift the control panel and set it aside. Now, remove any screws that are securing the top panel of the washer to the frame using a screwdriver or pliers. Carefully lift the top panel and set it aside.

Removing the Damaged Rubber Seal

Once the top panel is removed, you will be able to access the rubber seal. Start by removing the spring clamp that secures the rubber seal to the washer drum using pliers. Once the spring clamp is removed, pull the rubber seal off the drum gently. You may want to use a razor blade or a sharp knife to cut through any adhesive that is holding the rubber seal to the drum. Be careful not to damage the drum while removing the rubber seal.

Installing the New Rubber Seal

To install the new rubber seal, start by fitting it into the groove on the washer drum. Once the rubber seal is in place, secure it to the drum using the spring clamp that you removed earlier. Make sure that the rubber seal is snugly fitted and that there are no gaps between the seal and the drum. Finally, reattach the top panel, control panel, and detergent drawer, in reverse order from how you removed them.

Conclusion

Replacing a rubber seal on a Whirlpool front load washer is a job that can be done in a few hours with basic tools and some patience. By following the steps outlined in this article, you can easily replace a damaged rubber seal and keep your washer in top condition. Remember to always follow safety precautions and refer to your Whirlpool washer manual for specific instructions on your machine’s model.