how to replace rear bearing on ge front load washer

Front load washers have become very popular in recent years due to their efficiency and reliability. However, just like any other machine, they experience wear and tear over time. One of the most common problems that homeowners face with their front load washer is a noisy spin cycle that is caused by worn-out rear bearings. In this article, we'll show you how to replace the rear bearing on a GE front load washer.

Step 1: Preparation

To replace the rear bearing on your washer, you will need a few tools, including a screwdriver, pliers, an adjustable wrench, and a new rear bearing kit. You can purchase the kit from your local hardware or appliance store. Before beginning the repair process, make sure that the washer is unplugged and the water supply is turned off. Also, ensure that the washer is placed on a level surface and you have enough space to work around it.

Step 2: Remove the Rear Panel

To gain access to the rear bearing, you will first need to remove the back panel of the washer. Use your screwdriver to remove the screws that secure the panel to the washer. Set the screws aside in a safe place so you won't lose them. Once the panel is removed, you should be able to see the drum and the bearings.

Step 3: Remove the Drum

The next step is to remove the drum from the washer. This can be a bit tricky, so make sure you have someone to assist you. Start by removing the bolt that holds the pulley to the drum. You may need to use your pliers to hold the pulley in place while you remove the bolt. Once the bolt is removed, pull the pulley off the drum. Then, use your wrench to remove the nut that holds the drum to the drive shaft. Again, you may need to use your pliers to hold the shaft while you remove the nut. Once the nut is removed, you can pull the drum away from the washer.

Step 4: Replace the Rear Bearing

Now that you have removed the drum, you can access the rear bearing. To remove the old bearing, use your pliers to grip the seal and pull it out of the bearing. Then, use your wrench to remove the bolts that secure the bearing to the drum. Once the bolts are removed, you can pull the old bearing out of the drum. Next, insert the new bearing into the drum and secure it with the bolts. Finally, replace the seal by pressing it into place with your pliers.

Step 5: Reassemble the Washer

With the new rear bearing in place, it's time to reassemble the washer. Start by aligning the drum with the drive shaft and securing it with the nut. Then, replace the pulley and secure it with the bolt. Once the drum is reassembled, you can replace the back panel of the washer and secure it with the screws. Finally, plug in the washer and turn on the water supply to test it.

Conclusion

Replacing the rear bearing on a GE front load washer is a simple process that can be completed with a few basic tools. By following these steps, you can extend the life of your washer and ensure that it runs smoothly for years to come. If you have any doubts about your ability to complete this repair, don't hesitate to consult a professional.