Samsung front load washers are known for their durability and high performance. However, they can develop leaks over time, and one of the most common causes is a faulty door seal. The door seal on a Samsung front load washer helps to prevent water from leaking out during the wash cycle. Over time, it can become damaged or worn out, and it will need to be replaced. In this article, we will show you how to remove the door seal on a Samsung front load washer.
Tools and Materials Required
Before you start, you'll need a few tools and materials:
- Phillips screwdriver
- Flathead screwdriver
- Pliers
- New door seal
Preparation
Before you remove the door seal, you need to make sure that your washer is unplugged and disconnected from the water supply. You should also ensure that the washer drum is empty.
Removing the Door Seal
1. Start by opening the washer door and locating the door seal. You will see a lip around the edge of the seal. 2. Use a flathead screwdriver to gently pry the lip away from the washer. Be careful not to damage the seal or the washer. 3. Once you have pulled the lip away from the washer, you will see a metal ring with a spring. Use your pliers to remove the spring. 4. After removing the spring, you can now pull the door seal away from the washer. You may need to use the flathead screwdriver to loosen it from the washer. 5. Once you have removed the door seal, inspect it for any damage or wear. If it is damaged or worn, you will need to replace it with a new one.
Installing the New Door Seal
1. Start by placing the new door seal onto the washer drum. Make sure that it is properly aligned and that the holes line up with the screw holes. 2. Next, place the metal ring onto the door seal. 3. Carefully stretch the spring over the metal ring and onto the door seal. Use your pliers to help you stretch the spring into place. 4. Once the spring is in place, use your hands to push the door seal lip back onto the washer. Make sure that it is properly seated and that there are no gaps. 5. Finally, tighten the screws around the door seal using your Phillips screwdriver.
Conclusion
Removing and replacing the door seal on your Samsung front load washer is not a difficult task, but it does require some patience and care. By following the steps outlined in this article, you should be able to easily remove and replace your old door seal with a new one. A properly installed door seal will help to prevent water leaks and prolong the life of your washer.
