If you own an LG front load washer, you may notice that the gasket around the door collects mildew and begins to smell. This is a common problem that plagues front load washers due to the way they operate. However, replacing the gasket is a relatively easy process that you can do at home. This article will guide you through the steps of changing the LG front load washer gasket in simple and easy-to-follow instructions.
Tools Required
Before you begin, ensure that you have all the necessary tools that you will need to change the LG front load washer gasket. These include a screwdriver, pliers, a utility knife, a towel, and a new gasket. Make sure that the replacement gasket matches the make and model of your LG washer.
Steps to Change LG Front Load Washer Gasket
Here are the steps you'll need to follow to replace the front load washer gasket:
Step 1: Unplug the Washer
Before you begin, unplug the washer from the electrical socket to ensure your safety during the installation process.
Step 2: Remove the Old Gasket
The first step in replacing the gasket is to remove the old one. Start by opening the front door and locating the retaining ring that secures the gasket in place. Using a screwdriver or pliers, remove the ring and carefully pull out the old gasket. Use a towel to clean the area where the gasket was located, paying close attention to the areas that were covered by the gasket.
Step 3: Install the New Gasket
Now that you have removed the old gasket, it's time to install the new one. Start by aligning the gasket in the same position as the old one. Once it's in place, fit the retaining ring back over the gasket, making sure that it's secure. Test the door to ensure that it closes properly and that the gasket is properly aligned.
Step 4: Test the Washer
Now that you have replaced the gasket, plug the washer back in and run a cycle to ensure that there are no leaks. Wipe down the exterior of the washer to remove any fingerprints or smudges.
Maintenance Tips to Prevent Mildew
Now that you've replaced the gasket, you'll want to take steps to prevent mildew from forming in the future. Here are a few maintenance tips to help you keep your LG washer looking and smelling fresh:
Tip 1: Keep the Washer Door Open
After each wash cycle, leave the washer door open to allow air to circulate through the machine. This will help prevent moisture from building up inside the machine and causing mildew.
Tip 2: Use High-Efficiency Detergent
Front load washers require high-efficiency detergent to prevent suds from building up inside the machine. Use only the recommended amount of detergent to avoid any buildup that could cause mildew.
Tip 3: Wipe Down the Gasket
After each use, use a towel to wipe down the gasket and remove any excess moisture. This will prevent moisture buildup that could lead to mildew.
Tip 4: Run a Cleaning Cycle Monthly
Run a cleaning cycle once a month to keep your washer smelling fresh and clean. This will remove any mildew that may have formed and prevent it from coming back.
Conclusion
Replacing the LG front load washer gasket is a relatively easy process that can be done at home. By following these simple instructions, you'll be able to replace the gasket and prevent mildew from forming in the future. Remember to perform regular maintenance to keep your washer smelling fresh and clean.
"