how to change bearings in lg front load washer

How to Change Bearings in LG Front Load Washer

LG front load washers are widely popular for their functionality and durability. However, after prolonged use, they may develop issues like a loud noise during the spinning cycle which indicates that the bearings need to be replaced. Replacing the bearings is a challenging task, but it can be done with the right tools and instructions. In this article, we will guide you through the steps to change bearings in LG front load washer.

Gather Required Tools and Supplies

Before you start the process, you need to gather the necessary tools and supplies. Here's what you'll need:- A new set of bearings- Tub seal- Grease- Screwdriver- Adjustable wrench- Pliers- Putty knife- Duct tape- Towels

Preparation

The first step is to prepare the washer for disassembly. Unplug the washer from the power source and turn off the water supply. Then, unscrew the back panel of the washer using a screwdriver. Locate the rotor at the back of the washer and remove it by unscrewing the bolts. Once the rotor is removed, pull the stator away from the tub, and tape it to the side of the washer using duct tape.

Removing the Tub

Next, you need to remove the tub to access the bearings. To do this, remove the retaining spring around the tub using pliers. Once the spring is removed, lift the tub out of the washer. Use a putty knife to remove the old tub seal and wipe the area clean. Now, use the adjustable wrench to remove the bolt holding the spin basket and drum together. Once the bolt is removed, lift the drum away from the spin basket.

Replacing the Bearings

With the tub removed, you can now access the bearings. Use a hammer and chisel to remove the old bearings. Once the old bearings are removed, clean the area thoroughly. Now, insert the new bearings into place. Apply a thin layer of grease around the new bearings, and install the drum and spin basket back together. Tighten the bolts and re-install the tub seal.

Finishing Up

Once the new bearings are installed, it's time to reassemble the washer. Insert the tub back into the washer and re-attach the retaining spring using the pliers. Replace the back panel of the washer, and screw it back in place using the screwdriver. Reconnect the water supply and plug the washer back in. Turn on the washer and test it to ensure that it's running smoothly.In conclusion, changing bearings in LG front load washer is a complex and time-consuming task. However, with the right tools and instructions, it can be done at home with minimal effort. Follow the steps mentioned above, and you should be able to replace the bearings in your LG front load washer without any problems.