how to make a magazine loader

Magazine loaders are great accessories to have when you're out on the range. They make loading magazines quicker and more efficient, saving time and energy. They’re easy to use and with a little know-how, you can make your own. In this guide, we'll go over how to make your own magazine loader in just a few simple steps.

What You'll Need

Before we get started, you'll need a few materials to make a magazine loader:- A 3-inch PVC pipe- A PVC cap- A PVC glue - A saw- A drill- Sandpaper

Step 1: Measure and Cut Your PVC Pipe

To start, measure and cut the PVC pipe. For most magazines, a 3-inch PVC pipe will work best. Cut the pipe to a length of 6 inches. If you have other types of magazines, adjust the length of the PVC pipe as necessary.

Step 2: Sand the Pipe

Using sandpaper, rough up the inside of the PVC pipe. This will help the rounds slide into the magazine more easily.

Step 3: Drill Holes in the Cap

Take the PVC cap and drill several holes into it. The size and number of holes will depend on the number of rounds in your magazine. Aim for one hole for every round in the magazine. These holes will act as guides for the rounds as you load them into the magazine.

Step 4: Glue the Cap on the Pipe

Using PVC glue, attach the cap to one end of the pipe. Allow the glue to dry completely before moving on to the next step.

Step 5: Loading Your Magazine

To use your homemade magazine loader, simply insert the rounds into the PVC pipe and slide them down. They will fall into place in your magazine through the holes you drilled into the cap. This process saves a lot of time and hassle when you are reloading your magazines on the range.

Conclusion

Making your own magazine loader is a simple and cost-effective way to improve your range experience. With just a few simple steps and inexpensive materials, you can create a magazine loader that will help you load your magazines quickly and easily. Give it a try, and see how much time and effort it can save you on the range.