how to install load resistors for led trailer lights

If you own a trailer with LED lights, you may have experienced hyperflashing or flickering lights. This is caused by the difference in power consumption between LED lights and traditional incandescent lights. To fix this issue, you need to install load resistors for your LED trailer lights. In this article, we will guide you on how to install load resistors for LED trailer lights.

What are Load Resistors?

Load resistors are simply resistors that are installed in parallel with the LED lights to reduce the power consumption and provide a load to the circuit. They are also known as LED equalizers or LED compensators. Load resistors are necessary because LED lights have a lower resistance than traditional incandescent lights, which can cause hyperflashing or flickering if not addressed.

Steps to Installing Load Resistors

1. Determine the correct load resistor size. The size of the load resistor you need depends on the power consumption of your LED lights. You can find this information in the owner’s manual or by checking the wattage of the LED lights.2. Locate the ground wire. You will need to connect the load resistor to the ground wire of the LED light. The ground wire is usually black or green.3. Disconnect the LED light. You will need to disconnect the LED light from the wiring harness to install the load resistor.4. Connect the load resistor. Connect one end of the load resistor to the ground wire of the LED light and the other end to the positive wire.5. Reconnect the LED light. Once you have installed the load resistor, reconnect the LED light to the wiring harness.6. Test the lights. Turn on the trailer lights and check if the hyperflashing or flickering has been resolved. If not, you may need to install additional load resistors.

Tips and Precautions

- Make sure the load resistor is installed in a location that does not get too hot, as this can cause damage to the resistor.- Use a wire splicer or a soldering iron to connect the wires. Avoid using wire nuts, as they can come loose over time.- Double-check the wiring before turning on the trailer lights to avoid any accidents.- If your LED trailer lights have multiple bulbs, you may need to install multiple load resistors.

Conclusion

Installing load resistors for LED trailer lights is a quick and easy solution to fix hyperflashing or flickering lights. By following these simple steps, you can ensure that your LED trailer lights are working properly. Remember to take precautions and double-check your wiring to avoid any accidents. Happy trailering!"