how to replace belt on whirlpool front load dryer

Whirlpool front load dryers are a great addition to any household, providing an efficient and effective way to keep clothes clean and dry. Like any appliance, it’s important to properly maintain and repair your dryer as needed. One common issue that can arise is the need to replace the belt. In this article, we’ll provide step-by-step instructions on how to replace the belt on a Whirlpool front load dryer.

Tools and Materials Needed

Before we begin, it’s important to make sure you have all the necessary tools and materials. Here’s a list of what you’ll need:- Multi-screwdriver- Socket wrench- Prying tool- New belt (make sure it’s compatible with your dryer’s model)

Preparing the Dryer

The first step in replacing the belt on your Whirlpool front load dryer is to unplug the machine and turn off the water supply. Next, you’ll need to remove the lint trap and any other attachments from the top of the machine. Using your screwdriver or prying tool, remove the screws or clips holding the top of the dryer in place. Once it’s loose, lift it up and off the machine.

Removing the Old Belt

With the top of the dryer off, you’ll now have access to the drum and belt. You may notice that the belt has broken or is stretched out. Using your socket wrench, remove the bolts holding the bracket in place that’s located near the motor. This will release tension on the belt, allowing you to remove it from the drum and motor. Take the old belt out of the machine and discard it.

Installing the New Belt

Now it’s time to install the new belt. Begin by wrapping the belt around the drum, making sure it’s positioned correctly. You should see marks on the drum indicating where the belt should go. Next, loop the belt around the motor pulley, making sure it’s properly aligned and tightened. Once the new belt is securely in place, use your hand to rotate the drum a few times to make sure it’s properly aligned with the belt.

Putting Everything Back Together

With the new belt installed and the drum properly aligned, it’s time to put everything back together. Begin by replacing the top of the dryer, making sure all screws and clips are securely in place. Reattach the lint trap and any other attachments you removed earlier. Finally, plug the machine back in and turn on the water supply. You should now be able to turn on the dryer and watch as it runs smoothly with its new belt in place.

Conclusion

Replacing the belt on a Whirlpool front load dryer may seem daunting at first, but with the right tools and a little time, it’s a relatively simple process. By following the steps outlined in this article, you’ll be able to replace the belt on your dryer and get back to effectively drying clothes in no time. As always, remember to turn off the machine before attempting any repairs or maintenance.