how to remove tub from lg top load washer

Removing the tub from an LG top load washer can be a daunting task if you're not familiar with the process. It may seem complicated and difficult, but with the right tools and a little bit of patience, anyone can do it. In this article, we will provide a step-by-step guide on how to remove the tub from your LG top load washer.

Tools Required

Before you start, there are a few tools that you will need to complete the job. These include:- Screwdriver- Pliers- Wrench- Rubber mallet- Allen wrench- Gloves and safety glassesMake sure to have all the tools ready before starting as this will save you time and frustration during the process.

Steps to Remove Tub

Below are the steps to follow when removing the tub from your LG top load washer.

Step 1: Preparation

Before you start to remove the tub, switch off the power source and unplug the machine. Then, remove the water supply hoses, drain hose, and power cord from the back of the washer. Next, remove the control panel, which is usually held in place by screws or clips. Once you have removed the control panel, locate the lid switch wire harness and disconnect it.

Step 2: Remove the Agitator

After you've disconnected the lid switch wire harness, take off the agitator cap and remove the bolt that holds it in place. Lift the agitator out and set it aside.

Step 3: Loosen the Tub Bolt

Using a wrench or pliers, loosen the tub bolt located in the center of the tub. Then, use an Allen wrench to remove the tub center cap. Once you have removed this, you will see the tub bolt that needs to be removed.

Step 4: Remove the Tub

Using a rubber mallet, tap on the top of the agitator shaft to loosen the tub. Once it has been separated from the agitator shaft, pull the tub up and out of the washer. Make sure to support the tub during this process as it may be heavy.

Conclusion

Removing the tub from an LG top load washer may seem like a daunting task, but by following these steps, it can be easily accomplished. Make sure to have all the required tools before starting and always take your time. Safety is also important, so wear gloves and safety glasses throughout the process. With patience and diligence, you can successfully remove the tub from your LG top load washer.