how to load weed eater string ryobi

Weed eaters are essential tools for maintaining your lawn or garden. They help trim and cut grass and weeds that grow in places that your lawn mower cannot reach. The Ryobi weed eater is a great tool to have, but loading the string can be tricky. In this article, we will explain how to load weed eater string on a Ryobi weed eater.

Step 1: Gather Your Materials

Before you start, you will need to gather a few materials. You will need a new trimming line, preferably of the same size as the one that was previously used. You will also need a pair of pliers and flathead screwdriver. Once you have all your materials, you can move on to step 2.

Step 2: Remove the Spool

The first thing you need to do is remove the spool from the Ryobi weed eater. To do this, you will need to press the tabs on both sides of the spool until it pops out. Once the spool has been removed, lay it on a flat surface.

Step 3: Remove the Old String

Next, you need to remove the old string from the spool. This is usually done by pulling the old trimming line out of the spool. If the line is wound too tightly, use your pliers to loosen it before pulling it out.

Step 4: Wind the New String

Now it’s time to wind the new trimming line onto the spool. Start by feeding the line into the eyelet on the spool and winding it in the direction indicated on the spool. Make sure to wind the line tightly and evenly. Once you have wound the line around the spool, leave about 6 inches of the line hanging from the spool.

Step 5: Reassemble the Weed Eater

Once you have loaded the new string onto the spool, it’s time to put everything back together. Thread the line through the hole on the weed eater’s head, making sure that it is aligned with the opening. Snap the spool back onto the weed eater and give it a tug to make sure it is securely in place. Finally, turn your weed eater on to check that it is working correctly.

Conclusion

By following these steps, you should be able to load your weed eater string on a Ryobi weed eater with ease. Remember to use the same size trimming line as the one that was previously used, and wind the line tightly and evenly onto the spool. With a little practice, you will be able to load your weed eater in no time.